Finished bundling wires that go to the input and output plugs on the Lightspeed ignition boxes. Much of the time was spent securing the screws that secure the d-sub plugs into the ignition units. With the spacing of the two boxes and the fact that the d-sub connectors face each other on the end of the units, you are left with very little room to get a screwdriver in to reach the screws. I then tied up the extra wire that I had at the end of the run to the boxes. It isn't the cleanest part of my electrical system, but the necessity of soldering the solder cup type d-sub connectors in an accessible area made it pretty difficult to end up with a nice even wire bundle.